IronPort Systems 4108GL Manual do Utilizador descarregar pdf (Página 141)

100

101

8-11

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Time Protocols

For example, to select SNTP and configure it with unicast mode and an SNTP

server at 10.28.227.141 with the default server version (3) and default poll

interval (720 seconds):

HP4108(config)# timesync sntpSelects SNTP.

HP4108(config)# sntp unicastActivates SNTP in Unicast mode.

HP4108(config)# sntp server 10.28.227.141Specifies the SNTP

server and accepts

the current SNTP server version

(default: 3)

Figure 8-8. Example of Configuring SNTP for Unicast Operation

If the SNTP server you specify uses SNTP version 4 or later, use the sntp server

command to specify the correct version number. For example, suppose you

learned that SNTP version 4 was in use on the server you specified above (IP

address 10.28.227.141). You would use the following commands to delete the

server IP address and then re-enter it with the correct version number for that

server:

Figure 8-9. Example of Specifying the SNTP Protocol Version Number

In this example, the Poll Interval and the Protocol

Version appear at their default settings.

Note: Protocol Version appears only when there is an

IP address configured for an SNTP server.

Deletes unicast SNTP server entry.

Re-enters the unicast server with a non-

default protocol version.

show sntp displays the result.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 482 483

Comentários a estes Manuais

Sem comentários

IronPort Systems 4108GL Manual do Utilizador Página 141

Comentários a estes Manuais